Produktai skirti metopeteksas (2)

In many plastic systems, such as elastic PVC floor coverings, a wide variety of Incorporated inorganic fillers. However, these inorganic additives do not show any significant tendency to be incorporated into the liquid constituents of a plastisol. Without suitable additives, this is practically impossible. Provides for an optimal distribution of the filler NEWOS for the process step of dispersing innovative and market-proven process aids under the name NEWOTEC.

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul