Produktai skirti metopeteksas (5)

In many plastic systems, such as elastic PVC floor coverings, a wide variety of Incorporated inorganic fillers. However, these inorganic additives do not show any significant tendency to be incorporated into the liquid constituents of a plastisol. Without suitable additives, this is practically impossible. Provides for an optimal distribution of the filler NEWOS for the process step of dispersing innovative and market-proven process aids under the name NEWOTEC.

L-Lysine HCI, fermentativ, Anti-Verklumpung

Eine natürliche Lösung für die täglich notwendige Zufuhr an Calcium mit Aquamin®- ein bio verfügbares Calcium aus der roten Meeresalge. Defizite ausgleichen ist besser .... Personen, die zu wenig Calcium in Ihrer täglichen Ernährung aufnehmen, da Sie keine Milchprodukte essen, sich vegan ernähren..., können die Calciumzufuhr mit Hilfe von OsteoAqua effects so ausgleichen und optimieren.Aquamin® ist ein natürliches Kalzium Präparat aus mineralisierten Meeresalgen (Lithothamnion sp.), die in bestimmten kalten und mittel-temperierten Meeren wachsen. Das hier eingesetzte Calcium - Aquamin® - unterliegt der ständigen wissenschaftlichen Kontrolle unter den Vorgaben der EU. EU: Deutschland weiß: weiß

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul

L-Selenomethionin 0,5 %