Produktai skirti bcl1015 hitachi (2)

The use of servo-hydraulic controls can significantly extend the range of applications for swivel motors. Larger loads can be slewed in a shorter time than is possible with purely hydraulic systems, where the damping travel is fixed. In conjunction with such a control system, the acceleration and braking behavior of the swivel motors can be specifically adapted to the requirements. This means that even fast and very precise movements with large masses can be safely mastered. We offer customized solutions for a wide range of applications. Our qualified team will be happy to advise you on design and realization. Specific torque [Nm/bar]:1,19 Operating pressure [bar]:200 Nominal torque [Nm]:238 Swivelling angle [ degrees° ]:250 Shaft end: (P) toothed shaft (Z) keyway key:P

The swivel motors with attached hydraulically released spring-applied multi-disc brake are recommended if a swivel position must remain unchanged once it has been reached – even over an unlimited period of time – despite the effect of a load torque. The brake is used solely to hold the load. It should only be noted that large transmission delays in the lines can cause time differences between the switching off of the swivel motor and the application of the released brake caused by spring force. In order to provide our customers with the right drive for all areas of application, the HSB swivel motor is available in a total of 5 different versions. We have listed the most important data below. You can find all further details in our data sheet. Specific torque [Nm/bar]:2,05 Operating pressure [bar]:200 Nominal torque [Nm]:410 Holding torque [Nm]:380 Swivelling angle [ degrees° ]:250 Shaft end: (P) toothed shaft (Z) keyway key:P